hardware|numark VIRTUAL DJ SOFTWARE - Hardware Manuals - Numark - NS6 - Controls - Loops

Hardware Manuals


Numark - NS6 - Controls

Loops


  1. MODE. Use this button to select how the IN, OUT, SELECT and RELOOP buttons will behave.
    If the Manual mode is selected the Led of this button will be lit white and if the Auto Loop mode is selected will be lit red.

  2. LOOP IN.
    Manual mode (white Led)
    Use this button to set a Loop In (Entry) point for manual loop. If a loop is triggered, press this button to set the Jogwheel to Loop In Adjust mode (led will blink) and use the jogwheel to fine adjust the Loop In position.

    Auto mode (red led)
    Use this button to trigger a 1 beat Loop.

    SHIFT action (in both modes)
    Hold SHIFT down and then press this button down to trigger a momentary (as long as the button is pressed) Loop Roll of 1/8 beat. Once the button is released, the track will resume to the position it would have been if the Loop Roll was never triggered.

  3. LOOP OUT.
    Manual mode (white led)
    Use this button to set a Loop Out (Exit) point for manual loop. If a loop is triggered, press this button to set the Jogwheel to Loop Out Adjust mode (led will blink) and use the jogwheel to fine adjust the Loop Out position.

    Auto mode (red led)
    Use this button to trigger a 2 beats Loop.

    SHIFT action (in both modes)
    Hold SHIFT down and then press this button down to trigger a momentary (as long as the button is pressed) Loop Roll of 1/4 beat. Once the button is released, the track will resume to the position it would have been if the Loop Roll was never triggered.

  4. SELECT.
    Manual mode (white Led)
    Enable/disable Smart Loop. When Smart Loop is enabled, manual loops will be automatically converted to auto-loops.
    When a Loop is triggered, use this button to set the Jogwheel to Loop Move Adjust mode (led will blink) and use the jogwheel to fine move/shift the Loop through the track.

    Auto mode (red led)
    Use this button to trigger a 4 beats Loop.

    SHIFT action (in both modes)
    Hold SHIFT down and then press this button down to trigger a momentary (as long as the button is pressed) Loop Roll of 1/2 beat. Once the button is released, the track will resume to the position it would have been if the Loop Roll was never triggered.

  5. RELOOP.
    Manual mode (white Led)
    Use this button to trigger the last triggered Loop (Reloop) or jump to the Loop In point if a loop is already triggered.

    Auto mode (red led)
    Use this button to trigger a 8 beats Loop.

    SHIFT action (in both modes)
    Hold SHIFT down and then press this button down to trigger a momentary (as long as the button is pressed) Loop Roll of 1 beat. Once the button is released, the track will resume to the position it would have been if the Loop Roll was never triggered.

  6. HALF (/2). Use this button half the size (in beats) of the loop

  7. DOUBLE (x2). Use this button double the size (in beats) of the loop

  8. ON/OFF. Use this button to trigger a loop of the selected size, or exit a Loop

  9. SHIFT<. Use this button to move the triggered loop backwards by 1 beat

  10. SHIFT>. Use this button to move the triggered loop forward by 1 beat


Effects