hardware|numark VIRTUAL DJ SOFTWARE - Hardware Manuals - Numark - NS6 - Controls - Effects

Hardware Manuals


Numark - NS6 - Controls

Effects


The NS6 offers 2 FX units (A and B) which are assigned to control the Effects on the left assigned deck (FXA), on the right assigned deck (FXB) or the Video Transition and Video Effects on Master (assigned with the MASTER FX A and B buttons)



  1. FXA/FXB button
    Press this button to trigger the selected Effect on either the left or right assigned decks.

    If the MASTER FX A button is pressed, use the FXA button to trigger the selected Video Transition

    If the MASTER FX B button is pressed, use the FXA button to trigger the selected Video Effect on Master

  2. FX MIX fader.
    Use this fader to control the 1st parameter of the selected Effect..

    If the MASTER FX A button is pressed, use the left MIX fader to control the 1st parameter of the selected Video Transition

    If the MASTER FX B button is pressed, use the right MIX fader to control the 1st parameter of the selected Video Effect on Master

  3. FX SELECT encoder.
    Use this encoder to select an Effect from the Effect list of VirtualDJ. Push the encoder to open/close the GUI of the selected Effect in the Browser in order to see and control (via the GUI) more effect parameters.

    If the MASTER FX A button is pressed, use the left FX SELECT encoder to select a Video Transition. Push the encoder to open/close the GUI of the selected Video Transition in the Browser in order to see and control (via the GUI) more effect parameters (if available).

    If the MASTER FX A button is pressed, use the right FX SELECT encoder to select a Video Effect for Master. Push the encoder to open/close the GUI of the selected Video Effect in the Browser in order to see and control (via the GUI) more effect parameters (if available).

  4. FX PRM knob.
    Use this knob to control the 2nd parameter of the selected Effect. Hold SHIFT down and then use the same knob to control the 3rd parameter of the selected Effect.

    If the MASTER FX A button is pressed, use the left FX PRM knob to control the 2nd parameter of the selected Video Transition (if available). Hold SHIFT down and then use the same knob to control the 3rd parameter of the selected Video Transition (if available).

    If the MASTER FX B button is pressed, use the right FX PRM knob to control the 2nd parameter of the selected Video Effect on Master (if available). Hold SHIFT down and then use the same knob to control the 3rd parameter of the selected Video Effect on Master (if available).


  5. FX MASTER ASSIGN A/B. If FX MASTER A is enabled, the left FXA unit of the NS6 will control the Video Transition. If FX MASTER B is enabled, the right FXB unit of the NS6 will control the Master Video Effect.

Front & Rear