hardware|numark VIRTUAL DJ SOFTWARE - Hardware Manuals - Numark - NV - Layout - Front & Rear Panels

Hardware Manuals


Numark - NV - Layout

Front & Rear Panels





  1. HEADPHONES SOCKET. Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.

  2. HEADPHONES MIX: Turn to mix between Cue and Program in the Headphone channel. When all the way to the left, only channels routed to Cue will be heard. When all the way to the right, only the Program mix will be heard.

  3. HEADPHONES SPLIT. When this switch is in the ON position, the headphone audio will be "split" such that all channels sent to Cue are mixed to mono and applied to the left headphone channel and the Program mix is mixed to mono and applied to the right channel. When the switch is in the OFF position, Cue and Program audio will be "blended" together.

  4. HEADPHONES VOLUME. Adjusts the volume level of the headphone output.





  5. POWER: Use included power adapter (12 V DC, 2 A, center-positive) to connect NV to a power outlet. While the power is switched off, plug the cable into NV first, and then plug the other end into a power outlet. Use the Power Switch to turn the NV on and off. Turn on the NV after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off the unit

  6. CABLE RESTRAINT. You can secure cables to this restraint to help avoid disconnecting them accidentally.

  7. USB. This USB connection sends and receives audio and control information from a connected computer.

  8. LINE INPUT. Connect your audio sources to this stereo input.

  9. MIC INPUT. Connect a 1/4" microphone to this input. Microphone controls are located on the top panel of the NV

  10. BOOTH OUTPUT (RCA): Use standard RCA cables to connect this output to a booth monitoring system. The level of this output is controlled by the Booth knob on the top panel.

  11. MASTER OUTPUT (RCA): Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the Master knob on the top panel.

  12. MASTER OUTPUT (XLR): Connect this low-impedance XLR output to a PA system or powered monitors. The level of this output is controlled with the Master knob on the top panel.

Mixer