hardware|ni VIRTUAL DJ SOFTWARE - Hardware Manuals - Native Instruments - Kontrol Z2 - Layout - Rear

Hardware Manuals


Native Instruments - Kontrol Z2 - Layout

Rear




  1. POWER SWITCH: Turns on/off the power on the device.

  2. POWER INPUT: Connect the supplied power cord.

  3. USB CONNECTOR: Use a standard USB cable to connect Kontrol Z2 with your computer.

  4. USB HUB: Use these USB ports to connect up to two other devices with your PC.

  5. BALANCED (XLR) OUTPUTS: Use these connectors to connect your device on a PRO grade amplifier or self-powered (active) speakers.

  6. RCA OUTPUTS: Use these connectors to connect your device on another mixer or consumer grade amplifier.

  7. BOOTH (TRS) OUTPUTS: Use these connectors to connect your device on your booth monitor speakers or amp.

  8. CHANNEL 2 INPUTS: Connect a turntable or a CD player to channel 2. You can control which of the two sources gets heard or routed to the VirtualDj’s timecode engine by flipping the PHONO/LINE (9) switch on the top of the mixer.

  9. CHANNEL 1 INPUTS: Connect a turntable or a CD player to channel 1. You can control which of the two sources gets heard or routed to the VirtualDj’s timecode engine by flipping the PHONO/LINE (9) switch on the top of the mixer.

  10. GROUND CONNECTORS: Connect your turntable’s ground connectors (if available) to eliminate ground static noise.

  11. AUXILIARY INPUT: Connect any line level auxiliary source.

  12. MIC INPUT: Connect your microphone.
Front