hardware|denon VIRTUAL DJ SOFTWARE - Hardware Manuals - Denon DJ - SC-3900 - Setup

Hardware Manuals


Denon DJ - SC-3900

SETUP


Step 1. Connections


Connect each SC-3900 to a USB port of your computer using the provided USB cable. If an external analogue dj mixer is used, connect each unit with an Input Channel of the mixer using proper RCA cables.
Connect the unit to a AC Power Outlet using the provided cable and power on the units from the rear switcher, once the connections are made.

Press the MIDI button at the top of the unit to set the SC-3900 to MIDI mode and allow controlling a VirtualDJ deck

While the decks initialize their communication with your computer the words "PC MODE" and "Connecting" should appear on the display. Once the initialization is complete, the words "PC MODE" and "Completed!" will appear on the display. Now your decks are ready !

Note : The Link connection cannot be used in MIDI mode. Each SC-3900 unit needs to be connected via a USB port to the computer

Step 2. Drivers


Windows : Download and install the Denon ASIO drivers from http://www.denondj.com/products/view/sc3900
Note : Before starting VirtualDJ, open the DENON DJ ASIO Control Panel and make sure that you see two devices listed, and that BOTH have a check mark in front of them. Close the DENON DJ ASIO control panel and then start VirtualDJ and continue with the sound configuration below.

Mac OSX : No drivers is required to be installed for Mac OSX computers.

Update the firmware of each unit to the latest version from http://www.denondj.com/products/view/sc3900

Step 3. VirtualDJ


Install VirtualDJ 8 from http://www.virtualdj.com/download/index.html (in case you have not done already)

Start VirtualDJ and login with your Account credentials. A Pro Infinity, Pro Subscription or Plus SC-3900 Controller License is required.

Find a detailed installation procedure at http://www.virtualdj.com/manuals/virtualdj8/quickstart.html

Detection Window
A detection window will appear when the unit is first connected with VirtualDJ, verifying proper connection

Click on the Use Soundcard button in order VirtualDJ to apply the pre-defined audio configuration using the built-in sound-card of the unit. Speakers need to be connected to the rear panel of the unit in this case.

Click to OK


The unit is now ready to operate with VirtualDJ.

Controls