AutoBPMMatch is still set to "no" and when I push play, the BPM changes. Sync isn't highlighted, I've gone through my settings and I can't figure out what's causing it.
Posted Thu 22 Nov 18 @ 5:16 am
smartPlay ?
Posted Thu 22 Nov 18 @ 5:38 am
Adion wrote :
smartPlay ?
The club I work at has a Pioneer XDJ-RX2 and I found out the other DJ took it home and changed a bunch of settings on it and the controller was the problem. Now I get to make fun of him for using the beat matching.
Thanks for answering at least.
Posted Thu 22 Nov 18 @ 6:41 am
XDJ-RX2 has a "QUANTIZE" button.
Push that button to turn off quantize, and then everything will work as you expect
Push that button to turn off quantize, and then everything will work as you expect
Posted Thu 22 Nov 18 @ 10:03 am
PhantomDeejay wrote :
XDJ-RX2 has a "QUANTIZE" button.
Push that button to turn off quantize, and then everything will work as you expect
Push that button to turn off quantize, and then everything will work as you expect
I was wrong, I used a basic Needs to Mixtrack 2 and it's doing the same thing. It's changing the BPM on play and not on load.
Posted Tue 27 Nov 18 @ 5:41 am
Adion wrote :
smartPlay ?
You might be right, it was set to "per decks".
Posted Tue 27 Nov 18 @ 5:48 am
PhantomDeejay wrote :
XDJ-RX2 has a "QUANTIZE" button.
Push that button to turn off quantize, and then everything will work as you expect
Push that button to turn off quantize, and then everything will work as you expect
Also, thank you for that knowledge.
Posted Tue 27 Nov 18 @ 5:49 am
kharix wrote :
You might be right, it was set to "per decks".
Adion wrote :
smartPlay ?
You might be right, it was set to "per decks".
Smart play does exactly what you describe, so there is a good chance that it was enabled on one of the decks (hence the per-deck setting)
Posted Tue 27 Nov 18 @ 6:17 am