Go to CONFIG -> Sound Setup and set your sound configuration to the following:


Download and install the latest ASIO driver (ASIO4TYPHOON) from http://help.vestax.co.jp/en/detail.php?id=115&id_page_url=86
Alternative link : http://virtualdj.com/files/ASIO4_TYPHOON_Installer-v10028.zip

Inputs: None
Outputs: Headphones (Master: Chan 1&2 / Headphones: Chan 3&4)
Sound card: ASIO -> Choose ASIO4Typhoon in the drop-down list.

Click APPLY.


No additional drivers are required - The Typhoon's sound card is supported by CoreAudio in MacOS.

Inputs: None
Outputs: Headphones (Master: Chan 1&2 / Headphones: Chan 3&4)
Sound card: 4 Out Card -> Choose the Typhoon in the drop-down list.

Click APPLY.

NOTE: You may need to configure the Typhoon's sound card for 4 channel audio in MacOS - Please see Configure 4 channel audio on Mac

Connect a pair of amplified speakers to master outputs on the rear of the Typhoon and your headphones into the headphone socket on the front of the Typhoon.


  • If you experience audio problems with the ASIO4Typhoon driver (Stuttering, crackling, etc.), try the following: Right-click on the VirtualDJ shortcut and choose Properties. Click on the Compatibility tab and choose Run this program in compatibility mode for: Windows XP (Service Pack 3) and tick the box Run this program as an administrator.

  • If you still have problems with the ASIO4Typhoon driver, you can try using the generic ASIO4ALL driver instead: http://www.asio4all.com - You will need to uninstall the ASIO4Typhoon driver and then configure ASIO4ALL correctly - Please see http://www.virtualdj.com/homepage/cioce/blogs/3832/_ENG__Vestax_VCI-300_Typhoon_Spin_audio_setup_on_Virtual_DJ_6.html

  • If the jogwheel won't scratch, please check that vinyl mode is enabled.

    Also, make sure that the touch sensor sensitivity knobs on the rear of the Typhoon are adjusted correctly to the appropriate level (If turned down, the touch sensor will no-longer respond.)

LE Skin : http://www.virtualdj.com/documents/Skins/Vestax%20Typhoon.zip

Return to Controller Config & Troubleshooting...