VDJPedia



 DN-S1200

Last edit by DJ_Fuze_MTL, Professional edition user on Fri 04 Nov 16 @ 12:14 am

Please ensure that you have the latest firmware installed on each Denon DN-S1200: http://www.denondj.com

Before starting VirtualDJ, press the SOURCE button and put both players into PC mode. Wait at least 30 seconds to allow the MIDI drivers to be detected, installed and enabled.

On a PC, check in the Denon ASIO control panel to ensure both players are listed and enabled.


Go to CONFIG -> Sound Setup and ensure that your sound settings are set to the following:

PC:

Inputs: None
Outputs: External Mixer
Sound card: ASIO -> Denon ASIO

Mac:

Inputs: None
Outputs: External Mixer
Sound card: 2 cards -> Choose each DN-S1200 in the drop-down lists.

Click APPLY.


Playing CD's or USB media

If you switch back to CD or USB media mode while VirtualDJ is running this will cut off the sound card and MIDI driver (The equivalent of pulling out the USB cable) and you will get an sound card error in VirtualDJ. Once you have switched back to PC mode, you can go to CONFIG -> Sound Setup and click APPLY to reset the sound.

If you wish to switch seamlessly between VirtualDJ and CD's/USB media, then you will need to use an external sound card with at least two stereo outputs such as Numark DJIO, Native Instruments Audio 2 DJ, etc.


Troubleshooting

  • Please ensure that you have the latest firmware installed on each Denon DN-S1200: http://www.denondj.com - If the units have older firmware installed, they may not work correctly.

  • Make sure both players are set to the default MIDI channel 1 (Do not change the second player to channel 2 or it will not be detected by VirtualDJ.)


Return to Controller Config & Troubleshooting...