hardware|numark VIRTUAL DJ SOFTWARE - Hardware Manuals - Numark - N4 - Layout - Other Controls

Hardware Manuals


Numark - N4 - Layout

EFFECTS, LOOPS, HOTCUES & SAMPLER





KEY

ACTION

SHIFT (SECONDARY) ACTION

S SHIFT
Press this button down to access secondary actions as described in the SHIFT ACTION column
27 LOOP IN
Set a Loop In (Start) point for a manual loop
Halves the size of the loop
28 LOOP OUT
Set a Loop Out (End) point for a manual loop. Use the same button to exit a loop if enabled
Doubles the size of the loop
29 RELOOP
Enables the last triggered loop, or exits the loop if enabled
When a loop is enabled, moves the loop backwards by the amount of beats equal to the current loop size
30 SMART
Turns Smart Loop mode on/off. When enabled, manual loops will auto-adjust to the nearest loop size (in whole beats) providing a seamless loop
When a loop is enabled, moves the loop forward by the amount of beats equal to the current loop size
31 EFFECT/DELETE
turns the selected Effect on/off
Enables/disables the HotCue Delete mode
32 EFFECT/CUE1
no action
Assigns or jumps (if assigned) to Hotcue 1.
If the Delete mode is enabled, deletes the Hotcue 1
33 SAMPLE1-3/CUE2
Trigger 1st/3rd Sample from the Selected Sampler Bank
Assigns or jumps (if assigned) to Hotcue 2.
If the Delete mode is enabled, deletes the Hotcue 2
34 SAMPLE2-4/CUE3
Trigger 2nd/4th Sample from the Selected Sampler Bank
Assigns or jumps (if assigned) to Hotcue 3.
If the Delete mode is enabled, deletes the Hotcue 3
35 FX PARAM1
Adjust the 1st Parameter of the selected Effect
Selects an Effect
36 FX PARAM2
Adjust the 2nd Parameter of the selected Effect
37 SAMPLE1
Select the Sampler Trigger mode
Adjust the Volume of Samples 1 (Left side) and 3 (Right side)
38 SAMPLE2
Select and loads a Sampler Bank
Adjust the Volume of Samples 2 (Left side) and 4 (Right side)


Front & Rear