 |
Forum: Hardware Technical Support - Topic: Time code problems - Page: 1 |
 |
| |
|
| | | | |
| |
Please post here all questions or comments about the hardware supported natively or by MIDI with Virtual DJ, Numark Virtual Vinyl, Numark Cue or AtomixMP3.
Hardware products
|
|
| - Post a new Message -
|
|
| Author |
- Topic: Time code problems - |
impal864
 |
| Posted Fri 09 May 08 @ 18:13:43 |
Just bought a set of new timecodes and a new turntables with mixer and cant get the TC value to 100%. On the wave forms it only goes in about 1/4 of the way in the advanced view. I have tried to use auto config and the values still jump around, but still only 1/4 of the way of the window. I have a pictures if needed to explain more.
|
jimmy b
 
 |
| Posted Fri 09 May 08 @ 18:37:16 |
If you get 100% timecode signal and the audio sounds good, then don't worry.
|
impal864
|
| Posted Fri 09 May 08 @ 20:26:11 |
Thanks for the response.
The signal jumps around from 50%-100%, is that normal should I worry about quality or latency? |
fullblast22
|
| Posted Thu 15 May 08 @ 12:37:35 |
also make sure your tcvs and cartridges are clean. |
jimmy b
|
| Posted Thu 15 May 08 @ 14:58:20 |
| impal864 wrote : | Thanks for the response.
The signal jumps around from 50%-100% |
Try this, Check Software RIAA Preamp (Timecode config>advance view) and see what you get.
I Checked that and my signal is solid at 100%.
|
impal864
|
| Posted Tue 20 May 08 @ 04:43:28 |
Ok so I just ordered some new shure m44-7 needles in hopes that would help...
Also what is the best way to clean the TCV's? |
DJ-ALF
|
| Posted Tue 20 May 08 @ 18:31:12 |
For cleaning you can find solution that is special made for cleaning records.
|
| - Post a new Message - |
|
| | |
 |
|
 |
|
