Hardware Manuals


Pioneer DJ - DDJ-WeGO4  

INSTALLATION


Firmware & Drivers


Firmware: Firmware: Update the firmware of the unit to the latest version from Pioneer Dj

Drivers: (Windows only) Install the latest drivers from Pioneer Dj

VirtualDJ 8 Setup


Download and install VirtualDJ 8 from our Downloads Page
(in case you have not done already)

Once VirtualDJ 8 is launched, a Login Window will appear. Login with your virtualdj.com account credentials. A Pro Infinity, a Pioneer DDJ-WeGO4 Plus or a Pro Subscription License is required to fully use the Pioneer DDJ-WeGO4

Without any of the above Licenses, the controller will operate for 10 minutes each time you restart VirtualDJ.
Buy a license

The Pioneer DDJ-WeGO4 is also operating with the bundled VirtualDJ Limited Edition.
Read further about the procedure required for VirtualDJ 8 LE at the Limited Edition Chapter


A detection window will appear next, asking to use or not the pre-defined audio setup with the built-in sound card of the DDJ-WeGO4 Click on the "Use Soundcard" if your speakers are connected to the Master Output of the DDJ-WeGO4.
You can still make changes in the Audio setup from VirtualDJ Settings->AUDIO tab.

Click to OK.

An additional Enter Keycode button will be available if the VirtualDJ 8 Limited Edition is installed.


The unit is now ready to operate.


Advanced Setup



MIDI Operation
The unit should be visible in the CONTROLLERS tab of Config and the “factory default” available/selected from the Mappings drop-down list. The factory default Mapping offers the functions described in this Manual, however those can be adjusted to your needs via VDJ Script actions.
Find more details at
VDJ Pedia


AUDIO Setup
The unit has a pre-defined Audio setup and a special button in the AUDIO tab of Config to provide that. Alternative Audio setups can be applied in the same window.


For further software settings please refer to the Manuals of VirtualDJ 8. Layout