Hardware Manuals


Denon DJ - SC LIVE 4 - Layout  

FRONT & REAR PANELS




Denon DJ SC Live 4 - Rear panel


  1. MIC 1/2 Connect up to 2 microphones to these sockets, using a 1/4" cable or XLR. The audio signals of these inputs are routed directly to the Program Mix and Cue Mix. The level of the Microphone Inputs are controlled from the top-left panel
    Set the MIC/AUX switcher to MIC if a Microphone is connected to the MIC 2 socket.

  2. AUX INPUT. Connect an audio source to this input. The audio signal of this input will be routed to the Master Output and its volume can be adjusted from the MIC 2 Volume knob at the top panel, if the MIC/AUX switcher is set to AUX.

  3. MASTER OUT (Balanced - XLR): Connect this low-impedance XLR output to a PA system or powered monitors. The level of this output is controlled with the Master Level knob on the top panel.

  4. MASTER OUT 2 (RCA): Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this output is controlled by the Master Level knob on the top panel.

  5. BOOTH OUT (XLR): Use 1/4" cables to connect this output to a booth monitoring system. The level of this output is controlled by the Booth/Speaker Vol knob at the top panel.

  6. SD CARD. Insert an SD Card as a storage device.

  7. USB 1/2. Connect USB storage devices in the ports of this USB hub. Keep in mind that the devices connected to these ports will not be available as computer devices, when the SC Live 4 is on Standalone (Engine) mode.

  8. USB B. Use the provided USB type B to type A cable to connect the device with a USB port of a computer. This USB connection sends and receives audio and control information from a connected computer.

  9. POWER ON/OFF: Use the included AC/DC power adapter to connect SC Live 4 to a power outlet. While the power is switched off, plug the cable into unit first, and then plug the cable into a power outlet.
    Use the Power Switch to turn the unit on and off. Turn on unit after all input devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off unit



    Denon DJ SC Live 4 - Front panel


  10. HEADPHONES SOCKET. Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.